is used for low-strength threadlocking where easy disassembly is required. It can also
be used as a general purpose thread sealant. Typical applications include small screws
and water and gas fittings.
Spec: MIL-S-46163 Type II, Grade M
is a general
purpose threadlocking adhesive for nuts, bolts and screws. Its medium strength perits
easy disassembly. It can be used for locking or sealing hydraulic and pneumatic
fittings and low strength bearing mountings.
Spec: MIL-S-46163 Type II, Grade N.
is a high
strength adhesive for threaded fasteners and studs up to one inch in diameter. On
threaded fasteners it is ideal for high load or high vibration applications.
Military Spec: MIL-S-46163 Type I, Grade K
is a high-strength adhesive for locking threaded fasteners that must withstand severe
conditions. It's designed to prevent fasteners from loosening under high shock or
severe temperature environments.
Spec: MIL-S-46163 Type II, Grade 0
is a high-strength, non-migrating adhesive for threaded fasteners and studs over one
inch in diameter. It has all the properties of omniFIT 1550 plus a higher viscosity
for added gap filling requirements of larger threads.
Spec: MIL-S-46163 Type I, Grade L
is a high-strength penetrating adhesive for locking preassembled parts. Its wicking
action allows it to be applied after parts are assembled. Commonly used for sealing
pinhole leaks in welded, soldered or brazed assemblies.
Spec: MIL-S-46163 Type III, Grade R
is a general purpose retaining compound used for mounting or retaining bearings,
gears, pulleys and rotors Especially useful for press-fit parts.Military
Spec: MIL-R-46082B Type I
is a high strength, high-temperature retaining compound used for mounting and
retaining cylindrical parts. Its medium viscosity gives good flow control and prevents
the adhesive from being drawn into unwanted areas.
Spec: MIL-R-46082B Type II
high-strength adhesive for locking and retaining bearings, gears and pulleys. It is
also useful for mounting sleeves, rotors and bushings.Military
Spec: MIL-R-46082B Type III
is a high viscosity, non-migrating retaining compound for uses requiring maximum gap
filling. It's thixotropic properties also allow it to be used on worn assemblies as a
quick repair solution.
INSTANT GASKET 10
low-strength adhesive used to seal flanges, pipes, pumps, fittings or housings where
easy disassembly is important.
INSTANT GASKET 20
is a high-strength adhesive suitable for most gasketing applications. It seals flanges
or dresses conventional gaskets where fast setting, gap-filling or structural
integrity is required.
Pipe Sealant with Teflon~ is a high performance anaerobic sealant for sealing all
threaded metal systems, including stainless steel and aluminum.E